Displaying 1-48 of 48 products
For Shure wireless systems, Also compatible with Line 6 Relay G50 / G90 and XDS-V75TR
For the Sennheiser EW Series
Switchable attenuator for microphones
-10 dB, -20 dB and -30 dB switchable, Suitable for dynamic microphones and condenser microphones, XLR in / out, Robust metal housing
For the Sennheiser SK-50 and SK-250, 3-Pin LEMO
Mute button for corded microphones, Reduction to approx. 60 dB, Passes phantom power, No popping on the outputs when switched on, Switchable by...
Balanced output switch
1x XLR input, 2x XLR output, Switchable 15 dB pad for channel A, 6 dB and 15 dB pad for channel B, Switchable GND Lift, Large foot switch, Grey...
To block phantom power, XLR 3-pole male to XLR 3-pole female, Phantom power is blocked - audio signal remains intact, Works in both directions,...
From low to high impedance, With 24 dB signal increase gain, Can also be used in the reverse direction, Balanced 3-pin XLR (f) to 6.3 mm jack plug
3-Pin mini XLR, For AKG PT pocket transmitters (except PT40), the Samson UT1L and VT2L, and the 4060 miniature microphone
Switchable In-Line Pad Adapter for Microphones
Compatible with 48 V phantom power, XLR male to XLR female, Robust metal chassis
For Beyerdynamic TS 300/800, Mipro ACT-707T/TE/TM/TS/MT103/303/801/808
Switchable -15/-20/-25 dB, Adapter with XLR male/female, Prevents input overloads at high levels, Also suitable for use with phantom power
For Lectrosonics LM, SM and UM series (suitable for low DC microphones)
Inline impedance converter
Allows low impedance microphones to be connected to high-impedance inputs, Cable approx. 10 cm
Joint adapter for 180° capsule rotation, Suitable for the 012 series from Oktava
Sennheiser adapter for Rode lavalier and HS1 microphones
Miniature Grille Soft Boost
3 dB Soft boost from 8 - 20 kHz
3.5 mm Adapter for Rode lavalier and HS1 microphones, For devices (recorders) and wireless systems with 3.5 mm stereo jacks (for 2V to 5V supplies)
Suitable for Sony Freedom on 4060 miniature microphones, Screw-on adapter included
For the MKH 8000 RF condenser microphone series, Switchable roll-off filter (-3 dB at 160 Hz), Low-cut filter (-3 dB at 16 Hz), Switchable -10dB...
For Audio Technica AEW-T1000D and ATW-T310
Passive cable for K1
6.3 mm mono jack connection for special applications, eg effect units with high-impedance connection
Unimute pad switch
For on / off, Push-to-talk, Push-to-mute, Can be triggered via external switch, 24 - 48 volt phantom permeable, Robust screw-fastened metal housing
Polar Pattern Converter for C1000
Changes the polar pattern from cardioid to hypercardioid
Compatible with ATM350 / AT803 / AT831 / AT829 / PRO35 / PRO70, Suitable for acoustic guitars and violins
Calibration Adapter 1/2"
For all measuring microphones of the M-Series
Microphone stand adapter
Compact and shock absorbing, For microphones with 19 mm diameter, For e.g. TM1, SCX1, SCX25, ADX51, F9, ADX12, ADX18, MG and MGN series etc.,...
Low Cut Filter
Is screwed between microphone preamp and capsule, Low frequencies are attenuated, Frequencies above 75 Hz pass through the filter unattenuated
Adapter cable for Stageclix Jack systems
From stereo jack female> mono jack male, Can be used as extension and adapter, Includes leather belt bag
For AKG microphones with the MicroDot connector, For connecting the Shure bodypack transmitters (mini-XLR 4-pin)
For Rode AHS1 headset, PinMic and lavalier microphone
For Rode AHS1 headset, PinMic and Lavalier microphones
Audio Technica adapter for Rode lavalier and HS1 microphones
For Rode HS1 headsets, lavalier microphones and PinMics, Suitable for MIPRO transmitters with 4-pin mini XLR connector
Suitable for AKG PT 40 pocket transmitters, Only for Lo-Sens DPA microphones
For Rode AHS1 headsets, PinMics and lavalier microphones, Audix RAD-360
For Countryman E6 and E6i Earset microphones
As elastic suspension with rubber-supported structure-borne sound decoupling, For Microphones of the Audix Micro-D-ADX20 and M1244 / M1250 / M1280...
Active Extension Tube
Tube swivel RG 8 included
Stereo Bracket featuring AK capsules on LC3 cables in coincidence and ORTF setup
For AKG microphones with the MicroDot connector, For connecting with Sennheiser bodypack transmitters with an EW plug (3.5 mm mini jack screw-fixed)
Replacement cable for WP-1X, For passive operation, 6.3 mm Mono jack connection for special applications, e.g. Effect units with high-impedance...
For AKG microphones with the MicroDot connector, For connecting with AKG and t.bone bodypack transmitters